Operation steps of CNC grinder
Ordinary grinder operation steps: preparation before grinding —> grinding wheel dressing —> moving the worktable to a suitable roll loading position —> loading the roll —> process adjustment of the grinding wheel frequency regulator, roll rotation speed and table moving speed —> grinding wheel rack fast forward —> The headstock spindle moves, the coolant opens—>manual feed—>grinding wheel holder exit—>the headstock spindle stops moving, and the coolant stops—>the worktable stops—>unloading the workpiece—>inspect—>mounting and marking.
Operation steps of CNC grinder
Operation steps of CNC grinder: pre-start —> turn on the machine power and control —> load tool —> install the part in the vise —> set the tool length offset —> set the part offset XY —> load the CNC program —> Idling —> Run the program —> Adjust the offset as needed —> Shut down.
Everyone knows that CNC grinders are different from ordinary grinders. CNC grinders are automatic grinders. Ordinary grinders are manual and require workers to use them. If the product is precise, it must be done by the masters, otherwise the workpiece The rework rate will be high. But the CNC grinder is different. After the program is programmed, the workpiece can be used after it is placed. Even one person can take care of two to three devices at the same time.
Matters needing attention during operation of CNC grinder
When the CNC grinder is in the production operation process, there will be some accidents, pay attention to safety factors, so we need a few precautions about the operation of the CNC grinder.
Operation steps of CNC grinder
1. Close the wheel cover and lock it before operation to prevent accidents. When the machine is not stopped, it is forbidden to move the protective cover of the grinding wheel, and the grinding wheel should be operated for 1-5 minutes before use. At this time, accidents should be prevented and no standing near the grinding wheel.
2. It is necessary to clamp the workpiece in the CNC grinding machine for processing operations to prevent the cutting feed from being clamped or insufficiently attracted to cause the workpiece to fly out and the grinding wheel to damage the major abnormalities (personnel, workpiece, equipment, tools) damage.
3. When the CNC grinder is processing, the operator should not stand facing the direction of the spark and the cutting line to avoid accidents.
4. When the grinding wheel is in operation, the grinding wheel needs to be raised or moved back to the upper left corner when installing the workpiece to open up the chance of being scratched by the grinding wheel when installing the workpiece or cleaning the disk.
5. The grinding wheel feeds from high to low and touches the higher point of the workpiece. It is strictly forbidden to feed from left to right and cut directly, which will cause a large amount of cutting and cause the grinding wheel to break.
6. Carefully observe the contact between the grinding wheel and the machined parts from the right side.
7. When the workpiece is touching the grinding wheel, it is forbidden to roll it into the worktable of the CNC grinder quickly.
8. It is forbidden to stop the grinding wheel at work by hand or other objects.
9. Once you find any abnormality in the operation of the CNC grinder, you should immediately unplug the power supply.
10. In the machining operations of CNC grinders, workers need to pay attention to the correctness of the operating steps at all times and devote themselves to the machining operations.
11. When working on the CNC grinder, the operator must always be alert, and it is forbidden to look around due to other external influences and try to avoid accidents.
